What Are The Components Of LED Panel Lights

The LED panel light has a unique design, good uniformity of illumination, soft light, comfortable and bright, which can effectively relieve eye fatigue. For such a good lighting product, what are the components of the LED panel light? 

What are the components of LED panel lights

1, panel light aluminum frame

It is the main channel for LED heat dissipation. The appearance is simple and generous. You can use ZY0907. The cost of stamping and opening by mold is low, and the processing cost is low; the IP rating of die-cast aluminum frame can be higher, the surface texture is good, and the overall appearance is beautiful, but the mold cost is invested in the early stage. Higher.

2, led light source

Usually 3528 is used for LED lamp beads, and some people use 3014 and 5050. The cost of 3014 and 5050 is low, and the light effect is slightly worse. The key is that the design of light guide dots is difficult. 3528 has high luminous efficiency and good versatility.

3, light guide plate

　The side LED light is refracted through the dots so that the light is uniformly led out from the front. The light guide plate is the key point of the quality control of the LED panel light. If the dot design is not good, the overall light effect seen is very poor. Generally, the light in the middle is dark on both sides, or there is a light band at the light entrance, or there is a partial dark area, or there may be inconsistent brightness at different angles. To improve the light efficiency of the light guide plate mainly depends on the design of the dots, followed by the quality of the plate, but there is no need to be superstitious in the first-line brand-name plates, and the light transmittance between qualified plates is usually the same. Generally, small LED lamp factories directly buy public light guide plates for use, so there is no need to re-proof the design. The public version used by many manufacturers is usually of good quality.

4, LED diffuser plate

  Lead the light of the light guide plate uniformly, and it can also play the role of blurring the dots. Diffusion plates generally use acrylic 2.0 sheets or PC materials, almost PS materials, acrylic has a lower cost and a slightly higher light transmittance than PC, acrylic is brittle and has weak anti-aging properties, and PC is slightly expensive, but it has anti-aging properties. Strong. After the diffuser is installed, the dots cannot be seen, and the light transmittance should be around 90%. The light transmittance of acrylic is 92%, PC is 88%, and PS is about 80%. You can choose the diffuser material according to your needs. Most manufacturers use acrylic materials.

5, reflective paper

Reflect the remaining light on the back of the light guide plate to improve the light efficiency, generally RW250.

6, rear cover

 The main function is to seal the LED panel light, generally 1060 aluminum is used, which can also play a role in heat dissipation.

7, drive power

There are two types of LED drive power supplies. One is to use a constant current power supply, which has high efficiency and a PF value of up to 0.95, which is cost-effective; the other is to use a constant voltage and constant current power supply, which has stable performance, but low efficiency and high cost. It is generally used. This kind of power supply is mainly exported, and the other party requires certification requirements and must use a safety-related power supply. In fact, it is very safe to use a constant current power supply at home, because it is difficult for users to access the power supply, and the lamp body itself uses safe low-voltage electricity.

8. Install the pendant

 Suspension wires, mounting brackets, etc. are used to install and fix accessories.