The Stringent Requirements Of LED Light Guide Technology Molding Technology

If the LED light guide plate has a warping shrink, particularly being forced deformation, it would greatly affect the shape of the luminance during the uneven scattering, under normal circumstances, which are also printed on the reflecting surface when caused problems. The above mentioned conditions are not supposed to exist, the next step is the forming technology which need to do a few. Internal stress remaining in the product to be little, if internal tilt, it will cause warpage, which makes optical skew, this is not a bad phenomenon, but there will be quality problems.

LED light guide plate forming technology which is required to be stable weight and size, quality management during the time, weight and size should be repeated stability, this cup must have high technical requirements and standards. Important to note is that when forming the mold temperature, set the thermostat at sixty degrees Celsius and seventy degrees Celsius, if the temperature is low, there will be surface flow marks. If the temperature is high, it will cause warpage. If you want to shape the fine achievements of transliteration, it must do more than eighty degrees Celsius temperature can be set.