LCD segment code display common fault problem summary
Jun 10, 2022
1. There is pollution inside the LCD: the general phenomenon is black spots, stains and fibres. Refers to the optical fiber inside the LCD.

2. LCD internal scratches: the general phenomenon is black and white lines, PI's scratches for line scratches.
3. LCD colour unevenness: the general phenomenon is uneven colour, rainbow, i.e. LCD colour unevenness, rainbow in the middle or strip side and colour strip unevenness, mainly from colour.
4. LCD background colour mismatch: the general phenomenon is that the overall colour of the LCD is very different from other LCDs. Generally not compared with the sample, our current processing capacity can not reach.
Ltd. specializes in precision parts processing, hardware mould manufacturing, connector terminals, etc.
5. Screen damage: customers claim that it is bad or lens is bad. In other words, the damaged part of the LCD is incomplete and damaged, including corner damage, edge damage and conductive layer damage (i.e. pin side damage, generally caused by a variety of human factors, may be the company and the customer together).
6. Poor glass cutting: Y-axis cutting and X-axis cracking resulting in partial protrusion or depression.
7. LCD pin scratch: that is, the LCD broken code screen pin side of the pin (commonly known as the conductive layer) is scratched or cut, resulting in open circuit, poor conductivity, etc., easily caused by ordinary customers when repairing.
8. LCD polarizer scratched, punctured: the general phenomenon in the industry known as mirror flower, mirror blur. In other words, the polarizer is damaged or damaged by blades and other hard hands (this will be caused by improper placement and use by the customer).
9. Water marks on the polarizer: streaks on the polarizer that can only be seen with the backlight. When applying alcohol or acetone to the conductive layer after lamination, the alcohol or acetone will seep into the conductive layer, and the customer will also seep into the conductive layer when wiping the pins.
10. No protective film: The protective film on the surface of the polarizer is torn off (general IC breakage). I think it was when I repaired
The LCD was broken and removed.
11. Polariser bubbles: small bubbles on the surface of the LCD polariser after installation, affecting the availability of the LCD (try to convince the customer to accept).
12. Reverse Paste: The customer called it a "paste" error, i.e. the polarizer was pasted in reverse, while the polarizer that should be pasted on the lower piece was pasted on the upper piece.
13. Protrusions, fibres: Dust, fibres and other contaminants fall onto the surface of the liquid crystal or the polarizer itself is dirty.
14. Polarizer corrosion: i.e. the polarizer is corroded and discoloured or deformed by chemical reaction with certain liquids.
15. Mixed colour: there are different types and performance of mixed colour products, different versions of mixed colour models, foreign manufacturers of mixed colour liquid crystals, and different periods of mixed colour liquid crystals, using the mark on the conductive layer of the liquid crystal as the basis for judgment.







