What factors should be paid attention to when installing the light guide plate?

 As a high-efficiency and high-energy board, the light guide plate with exquisite material selection has undoubtedly been widely praised for its use value and practical value. The light guide plate, which is very popular among customers, is constantly being praised by people for its advantages of energy saving, high efficiency, beauty and money saving, but they don't know anything about the installation of the light guide plate. There are clear requirements for the installation of light guide plates, and some unavoidable matters need to be paid attention to. But what factors need to be paid attention to when installing the light guide plate?

What factors should be paid attention to when installing the light guide plate?

1. Temperature

  The temperature setting is very important in the installation process of the light guide plate, because it is a light-sensitive material itself, and its sensitivity to temperature will be higher than other boards. The temperature referred to here is not the natural heat during installation, but the heat generated by the tool when the tool is installed. Whether it is the temperature of the sol or the temperature of the rotational speed generated by the tool, it needs to be set. Especially the ultra-thin light guide plate itself has high fluidity when it is installed, so the temperature setting is correspondingly high, but it should not be too high, otherwise there will be yellowing phenomenon, and the temperature setting of the first zone A lower value is required, which will prevent premature melting and shunting of the plastic.

2. Pressure holding speed

  When injecting and filling the light guide plate, it is necessary to use high injection pressure so that a better light guide plate can be integrated into the specific equipment. At this time, it is necessary to maintain the required level of injection molding speed. In addition, the filling speed of the light guide plate also needs extra attention. If the filling speed cannot be reached enough, the integration will fail. In particular, the injection molding of the ultra-thin light guide plate must use a high injection rate, so that the mold can be completely filled when the melt is not solidified. When conditions permit, multi-pole injection molding should be used as much as possible when filling to avoid trapped air.

  The above are the three major points that need to be paid attention to when installing the light guide plate, which are organized by the light guide plate sellers that are very popular with customers. Although there are many factors restricting the light guide plate in the initial installation, the installation is also more difficult, but this is only for the early installation, and it is very convenient for maintenance and cleaning in the later stage.