Touch screen full-fit technology introduction
May 02, 2018
The touch screen full-fit technology includes: In-Cell technology, On-Cell technology, OGS/TOL technology, and the like.
Touch Screen In-Cell Technology:
Refers to the technology that embeds the function of the touch panel into the liquid crystal pixels, that is, the touch sensor function is embedded in the display screen. Therefore, the original three-layer protective glass and the touch screen + display become two layers of protective glass + touch control. Functional display, which will make the screen lighter. This technology is mainly led by panel makers, and the threshold is relatively high.
In Cell Technology Screen Layer: In-Cell's screen consists of a layer of glass bonded LCD layer (touch screen on the LCD layer), a total of two layers.
Touch Screen On-Cell Technology:
On-Cell refers to a method of embedding a touch screen between a color filter substrate of a display screen and a polarizer. That is, a touch sensor is provided on the liquid crystal panel, and the difficulty of the technique is reduced compared with that of the industrial n-Cell.
On Cell is mostly used in Samsung AMOLED panel products. Technically, it has not yet been able to overcome the problems of thinning and color unevenness caused by touch.
On Cell Technology Screen Layers: A total of 3 layers of touchscreens and LCD layers bonded by a cover glass.
Touch Screen OGS/TOL Technology:
OGS technology integrates the touch screen and the protection glass, and applies a TO conductive layer on the inside of the protection glass. The coating and lithography can be performed directly on the protection glass. Because it saves one glass and one touch, the touch screen can do the same. Thinner and lower cost.
TOL refers to the OGS chip process, which is to make the border BM and functional electrodes after the white glass is well tempered. The strength of its products is higher than that of large-scale OGS. However, due to the low manufacturing efficiency, the cost is also high. Many domestic mobile phone brands use OGS technology. However, OGS still faces the problems of strength and processing costs, both of which need to be strengthened by secondary strengthening.
OGS technology screen layer: LCD layer is bonded by OGS layer, a total of 2 layers.
Touch screen other traditional full paste technology
GG, PG, GF, G1F, GF2, GFF, etc. all need to be affixed twice. The thickness is relatively thick and the yield is not high.
Screen permeability: OGS is the best, followed by In-Cell and On-Cell, and GFF is the worst.
Thinness: In-Cell is the lightest and thinnest This is one reason why mobile phones such as iPhone and P7 can be made lighter, OGS and On-Cell are next, and GFF is the worst.
Screen Intensity: GFF> On-Cell> OGS> In-Cell.
Touch effect: Strictly speaking, OGS touch sensitivity is better than On-Cell/In-Cell, but the touch is also related to the underlying optimization of the mobile phone system, such as using the In-Cell i Phone touch experience It's much better than many Android phones.
Cost Technical Difficulty: In-Cell/On-Cell is more difficult and costly, followed by OGS/TOL. The cost and technical difficulty of GFF is the lowest, so it is mostly used on thousands of machines.







